On 5/25/11 11:07 CDT, Jay Hanke wrote: >> Did you check that the Data Source for the graph is also using the >> 64-bit counters? >> >>> >>> Nothing special in logs either showing a problem. >>> >>> Steve - your own monitoring showing problems at all with data > > Are you looking at Gi-0/2? it is possible this is a problem on the Cisco side too, that port Gi-0/2 on the 3560E got changed to being in a port channel sometime this creates weird issues. They usually go away after a reboot. > Usually SNMPv1 issues will appear at right about 100 Mb/s on a five > minute average. We're pulling the po1 interface well over a Gig > without an issue. Also, the traffic will show up with spike and then > nothing (when the counter rolls over). > > Jay > > ######################################################################## > > To unsubscribe from the MICE-DISCUSS list, click the following link: > http://lists.iphouse.net/cgi-bin/wa?SUBED1=MICE-DISCUSS&A=1 -- =============================================== David Farmer Email:[log in to unmask] Networking & Telecommunication Services Office of Information Technology University of Minnesota 2218 University Ave SE Phone: 612-626-0815 Minneapolis, MN 55414-3029 Cell: 612-812-9952 =============================================== ######################################################################## To unsubscribe from the MICE-DISCUSS list, click the following link: http://lists.iphouse.net/cgi-bin/wa?SUBED1=MICE-DISCUSS&A=1